Dell PowerConnect 6224 - Page 793

IPv6 Routing Commands 793
IPv6 Forwarding Mode...........................
Enable
IPv6 Unicast Routing Mode......................
Disable
IPv6 Hop Limit..................................1
show ipv6 interface
Use the show ipv6 interface command in Privileged EXEC mode to show the
usability status of IPv6 interfaces.
Syntax
show ipv6 interface {brief|loopback loopback-id | tunnel tunnel-id |vlan
vlan-id
[ prefix ] }
• loopback-id — Valid loopback interface ID
•
tunnel-id — Valid tunnel interface ID
•
vlan-id — Valid VLAN ID.
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode
User Guidelines
This command has no user guidelines.
Examples
The following examples show the usability status of a IPv6 VLAN interface
individually and all IPv6 interfaces collectively in an abbreviated format.
console#show ipv6 interface vlan 3
IPv6 is enabled