1170 Power Over Ethernet Commands
power inline
The power inline command enables/disables the ability of the port to deliver
power.
Syntax Description
power inline { auto | never }
no power inline
•
auto
— Enables the device discovery protocol and, if found, supplies
power to the device.
•
never
— Disables the device discovery protocol and stops supplying power
to the device.
Command Mode
Interface Configuration (Ethernet).
Usage Guidelines
No specific guidelines.
Default Value
auto
Examples
console(config)#interface ethernet 1/g1
console(config-if-1/g1)# power inline auto
power inline legacy
The power inline legacy command enables/disables the ability of the switch
to support legacy Ethernet powered devices.
Syntax Description
power inline legacy
no power inline legacy
To Next Page
Loading...
