990 OSPFv3 Commands
show ipv6 ospf stub table
Use the show ipv6 ospf stub table command in Privileged EXEC mode to
display the OSPF stub table. The information below will only be displayed if
OSPF is initialized on the switch.
Syntax
show ipv6 ospf stub table
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode.
User Guidelines
This command has no user guidelines.
Example
The following example displays the OSPF stub table.
console#show ipv6 ospf stub table
AreaId TypeofService Metric Val Import
SummaryLSA
------------ ------------- ---------- -----------
------
0.0.0.10 Normal 1 Enable
show ipv6 ospf virtual-link
Use the show ipv6 ospf virtual-link command in Privileged EXEC mode to
display the OSPF Virtual Interface information for a specific area and
neighbor.
To Next Page
Loading...
