Dell PowerConnect 6224 - Clock Timezone Hours-Offset; No Clock Timezone

1104 Clock Commands
Examples
The following example enables the device to use Simple Network Time
Protocol (SNTP) to request and accept SNTP traffic from servers.
console(config)# sntp unicast client enable
clock timezone hours-offset
Use the clock timezone [ hours-offset ] [minutes minutes-offset ] [zone
acronym
] command to set the offset to Coordinated Universal Time (UTC).
If the optional parameters are not specified, they will be read as either '0' or
'\0, as appropriate.
Syntax
clock timezone hours-offset [minutes minutes-offset ] [zone acronym ]
• hours-offset — Hours difference from UTC. (Range: –12 to +13)
•
minutes-offset — Minutes difference from UTC. (Range: 0–59)
•
acronym — The acronym for the time zone. (Range: Up to four
characters)
Command Mode
Global Configuration
Default Value
No default setting
User Guidelines
No specific guidelines
Example
console(config)#clock timezone -5 minutes 30 zone IST
no clock timezone
Use the no clock timezone command to reset the time zone settings.