Dell PowerConnect 6224 - Ip Igmp Last-Member-Query-Interval

IGMP Commands 689
Command Mode
Interface Configuration (VLAN) mode
User Guidelines
This command has no user guidelines.
Example
The following example sets 10 as the number of VLAN 2 Group-Specific
Queries.
console#configure
console(config)#interface vlan 2
console(config-if-vlan2)#ip igmp last-member-query-
count 10
console(config-if-vlan2)#no ip igmp last-member-
query-count
ip igmp last-member-query-interval
Use the ip igmp last-member-query-interval command in Interface
Configuration mode to configure the Maximum Response Time inserted in
Group-Specific Queries which are sent in response to Leave Group messages.
Syntax
ip igmp last-member-query-interval tenthsofseconds
no ip igmp last-member-query-interval
• tenthsofseconds — Maximum Response Time in tenths of a second
(Range: 0-255)
Default Configuration
The default Maximum Response Time value is ten (in tenths of a second).
Command Mode
Interface Configuration (VLAN) mode