IPv6 Routing Commands 767
clear ipv6 neighbors
Use the clear ipv6 neighbors command in Privileged EXEC mode to clear all
entries in the IPv6 neighbor table or an entry on a specific interface.
Syntax
clear ipv6 neighbors [vlan
vlan-id
]
•
vlan-id
— Valid VLAN ID.
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode.
User Guidelines
This command has no user guidelines.
Example
The following example clears all entries in the IPv6 neighbor table.
console(config)#clear ipv6 neighbors
clear ipv6 statistics
Use the clear ipv6 statistics command in Privileged EXEC mode to clear IPv6
statistics for all interfaces or for a specific interface, including loopback and
tunnel interfaces. IPv6 statistics display in the output of the show ipv6 traffic
command.
Syntax
clear ipv6 statistics [vlan
vlan-id
| tunnel
tunnel-id
| loopback
loopback-id
]
•
vlan-id
— Valid VLAN ID.
•
tunnel-id
— Tunnel identifier. (Range: 0-7)
•
loopback-id
— Loopback identifier. (Range: 0-7)
To Next Page
Loading...
