Dell PowerConnect 6224 - Match Destination-Address Mac

QoS Commands 463
Command Mode
Class-Map Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example displays adding a match condition to the specified
class.
console(config-classmap)#match cos 1
match destination-address mac
Use the match destination-address mac command in Class-Map
Configuration mode to add to the specified class definition a match
condition based on the destination MAC address of a packet.
Syntax
match destination-address mac macaddr macmask
• macaddr — Specifies any valid layer 2 MAC address formatted as six two-
digit hexadecimal numbers separated by colons.
•
macmask — Specifies a valid layer 2 MAC address bit mask formatted as
six two-digit hexadecimal numbers separated by colons. This address bit
mask does not need to be contiguous.
Default Configuration
This command has no default configuration.
Command Mode
Class-Map Configuration mode
User Guidelines
This command has no user guidelines.