Dell PowerConnect 6224 - Area Nssa No-Redistribute

860 OSPF Commands
• integer — Specifies the metric of the default route advertised to the
NSSA. (Range: 1–16777214)
•
comparable — A metric type of nssa-external 1
•
non-comparable — A metric type of nssa-external 2
Default Configuration
If no metric is defined, 10 is the default configuration.
Command Mode
Router OSPF Configuration mode.
User Guidelines
This command has no user guidelines.
Example
The following example configures the metric value and type for the default
route advertised into the NSSA.
console(config-router)#area 20 nssa default-info-
originate 250 non-comparable
area nssa no-redistribute
Use the area nssa no-redistribute command in Router OSPF Configuration
mode to configure the NSSA Area Border router (ABR) so that learned
external routes are not redistributed to the NSSA.
Syntax
area area-id nssa no-redistribute
no area
area-id nssa no-redistribute
• area-id — Identifies the OSPF NSSA to configure. (Range: IP address or
decimal from 0–4294967295)
Default Configuration
This command has no default configuration.