Dell PowerConnect 6224 Command Line Interface Guide

734 IP Routing Commands
show ip route preferences
Use the show ip route preferences command in Privileged EXEC mode
displays detailed information about the route preferences. Route preferences
are used in determining the best route. Lower router preference values are
preferred over higher router preference values.
Syntax
show ip route preferences
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode
User Guidelines
This command has no user guidelines.
Example
The following example displays IP route preferences.
console#show ip route preferences
Local.......................................... 0
Static......................................... 1
OSPF Intra-area routes......................... 110
OSPF Inter-area routes......................... 110
OSPF External routes........................... 110
RIP............................................ 120

Dell PowerConnect 6224 Specifications

General

Switching Capacity	128 Gbps
Forwarding Rate	95.2 Mpps
Power Supply	100-240 VAC, 50/60 Hz
RAM	128 MB
Flash Memory	32 MB
Layer Support	Layer 2/3
Stacking	Up to 12 units
Weight	12.1 lbs
MAC Address Table Size	16, 000
Jumbo Frame Support	Up to 9, 216 bytes
Operating Temperature	0°C to 45°C
Storage Temperature	-40°C to 70°C
Humidity	10% to 90% (non-condensing)
Ports	24 x 10/100/1000BASE-T
VLAN Support	Yes (802.1Q)
Dimensions	17.3 x 13.8 x 1.7 in (440 x 350 x 44 mm)