System Management Commands 1339
User Guidelines
No specific guidelines.
Examples
console(config)#stack
console(config-stack)#standby 2
switch priority
Use the switch priority command in Global Configuration mode to configure
the ability of the switch to become the Management Switch. The switch with
the highest priority value is chosen to become the Management Switch if the
active Management Switch fails.
Syntax
switch
unit
priority
value
•
unit
— The switch identifier. (Range: 1–12)
•
value
— The priority of one backup switch over another. (Range: 0–12)
Default Configuration
The switch priority defaults to the hardware management preference value of
1.
Command Mode
Global Configuration mode
User Guidelines
Switches that do not have the hardware capability to become the
Management Switch are not eligible for management.
Once the priority of a switch has been configured, it cannot be reset to the
default. Switch priority is not affected by the "clear config" command.
To Next Page
Loading...
