Dell PowerConnect 6224 - Permit (Management)

Management ACL Commands 1153
console(config-macal)# permit ethernet 1/g1 priority
<1-64>
console(config-macal)# permit ethernet 2/g9 priority
<1-64>
console(config-macal)# exit
console(config)#management access-class mlist
The following example shows how to configure all the interfaces to be
management interfaces except for two interfaces, Ethernet 1/g1 and Ethernet
2/g9.
console(config)# management access-list mlist
console(config-macal)# deny ethernet 1/g1 priority
<1-64>
console(config-macal)# deny ethernet 2/g9 priority
<1-64>
console(config-macal)# permit priority <1-64>
console(config-macal)# exit
console(config) # management access-class mlist
permit (management)
Use the permit command in Management Access-List configuration mode to
set conditions for the management access list.
Syntax
permit ip-source ip-address [ mask mask | prefix-length ] [ethernet interface-
number
| vlan vlan-id |port-channel number ] [ service service ] [ priority
priority-value ]
permit { ethernet
interface-number | vlan vlan-id | port-channel number }
[service
service ] [priority priority-value ]
permit service
service [priority priority-value ]
permit priority
priority-value
• ethernet interface-number — A valid routed port number.