1260 SNMP Commands
snmp-server v3-host
Use the snmp-server v3-host command in Global Configuration mode to
specify the recipient of Simple Network Management Protocol Version 3
notifications. To remove the specified host, use the no form of this command.
Syntax
snmp-server v3-host {
ip-address
|
hostname
}
username
{traps | informs}
[noauth | auth | priv] [timeout
seconds
] [retries
retries
] [udpport
port
]
[filter
filtername
]
no snmp-server host
ip-address
•
ip-address
— Specifies the IPv4 address of the host (targeted recipient).
•
hostname
— Specifies the name of the host. (Range: 1-158 characters.)
•
username
— Specifies user name used to generate the notification.
(Range: 1-25 characters.)
•
traps
— Indicates that SNMP traps are sent to this host.
•
informs
— Indicates that SNMPv2 informs are sent to this host.
•
noauth
— Specifies sending of a packet without authentication.
•
auth
— Specifies authentication of a packet without encrypting it
•
priv
— Specifies authentication and encryption of a packet.
•
seconds
— Number of seconds to wait for an acknowledgment before
resending informs. This is not allowed for hosts configured to send traps.
The default is 15 seconds. (Range: 1-300 seconds.)
•
retries
— Maximum number of times to resend an inform request. This is
not allowed for hosts configured to send traps. The default is 3 attempts.
(Range: 0-255 retries.)
•
port
— UDP port of the host to use. The default is 162. (Range: 1-65535.)
•
filtername
— A string that is the name of the filter that define the filter for
this host. If unspecified, does not filter anything. (Range: 1-30 characters.)
Default Configuration
Default configuration is 3 retries and 15 seconds timeout.
To Next Page
Loading...
