Dell PowerConnect 6224 - Dot1 X Unauth-Vlan; Show Dot1 X Advanced

802.1x Commands 641
Example
The following example sets the guest VLAN on port 1/g2 to VLAN 10.
console(config-if-1/g2)#dot1x guest-vlan 10
dot1x unauth-vlan
Use the dot1x unauth-vlan command in Interface Configuration mode to
specify the unauthenticated VLAN on a port. The unauthenticated VLAN is
the VLAN to which supplicants that fail 802.1X authentication are assigned.
Syntax
dot1x unauth-vlan vlan-id
no dot1x unauth-vlan
• vlan-id — The ID of a valid VLAN to use for unauthenticated clients
(Range: 0-4093).
Default Configuration
The unauthenticated VLAN is disabled on the interface by default.
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
Configure the unauthenticated VLAN before using this command.
Example
The following example set the unauthenticated VLAN on port 1/g2 to VLAN
20.
console(config-if-1/g2)#dot1x unauth-vlan 20
show dot1x advanced
Use the show dot1x advanced command in Privileged EXEC mode to display
802.1x advanced features for the switch or for the specified interface. The
output of this command has been updated in release 2.1 to remove the