966 OSPFv3 Commands
passive-interface default
The passive-interface default command enables the global passive mode by
default for all interfaces. It overrides any interface level passive mode. Use the
“no” form of this command to disable the global passive mode by default for
all interfaces. Any interface previously configured to be passive reverts to non-
passive mode.
Syntax
passive-interface default
no passive-interface default
Default Configuration
Global passive mode is disabled by default.
Command Mode
Router OSPFv3 Configuration mode.
User Guidelines
There are no user guidelines for this command.
Example
console(config-rtr)#passive-interface default
redistribute
Use the redistribute command in Router OSPFv3 Configuration mode to
configure the OSPFv3 protocol to allow redistribution of routes from the
specified source protocol/routers.
Syntax
redistribute {static | connected} [metric
metric
] [metric-type {1 | 2}] [tag
tag
]
no redistribute {static | connected} [
metric
] [metric-type] [
tag
]
•
metric
— Metric value used for default routes. (Range: 0-16777214)
To Next Page
Loading...
