Dell PowerConnect 6224 - Sflow Polling

Sflow Commands 1223
The default IP address is 0.0.0.0
The default maximum datagram size is 1400.
The default owner string is the empty string.
The default receiver timeout is 0.
The default port is 6343.
Command Mode
Global Configuration mode.
User Guidelines
This command has no user guidelines
Example
console(config)#sflow 1 destination owner 1 timeout
2000
console(config)#sflow 1 destination maxdatagram 500
console(config)#sflow 1 destination 30.30.30.1 560
sflow polling
Use the sflow polling command to enable a new sflow poller instance for this
data source if rcvr_idx is valid. Use the “no” form of this command to reset
poller parameters to the defaults.
Syntax
sflow rcvr-index polling ethernet interfaces poll-interval
no sflow rcvr-index polling ethernet interfaces
• rcvr-index — The sFlow Receiver associated with the poller (Range: 1–8).
•
interfaces — The list of interfaces to poll.