Dell PowerConnect 6224 - Area Virtual-Link Dead-Interval

OSPFv3 Commands 943
no area areaid virtual-link neighbor-id
• areaid — Valid OSPFv3 area identifier (or decimal value in the range of 0-
4294967295).
•
neighbor-id — Identifies the Router ID or IP address of the neighbor.
Default Configuration
This command has no default configuration.
Command Mode
Router OSPFv3 Configuration mode.
User Guidelines
This command has no user guidelines.
Example
The following example creates the OSPF virtual interface for area 1 and its
neighbor router.
console(config)#ipv6 router ospf
console(config-rtr)#area 1 virtual-link 2
area virtual-link dead-interval
Use the area virtual-link dead-interval command in Router OSPFv3
Configuration mode to configure the dead interval for the OSPF virtual
interface on the virtual interface identified by
areaid and neighbor .
Syntax
area areaid virtual-link neighbor dead-interval seconds
no area areaid virtual-link neighbor dead-interval
• areaid — Valid OSPFv3 area identifier.
•
neighbor — Router ID of neighbor.
•
seconds — Dead interval. (Range: 1-65535)