OSPF Commands 899
Syntax
router ospf
Default Configuration
This command has no default configuration.
Command Mode
Global Configuration mode.
User Guidelines
The command prompt changes when the router ospf command executes.
Example
The following example enters into router OSPF mode.
console(config)#router ospf
console(config-router)#
show ip ospf
Use the show ip ospf command to display information relevant to the OSPF
router. This command has been modified to show additional fields.
Syntax
show ip ospf
Default Configuration
There is no default configuration for this command.
Command Mode
Privileged EXEC mode.
User Guidelines
Some of the information below displays only if you enable OSPF and
configure certain features. The following fields may be displayed:
To Next Page
Loading...
