Dell PowerConnect 6224 - Show Ipv6 Pimdm Interface

IPv6 Routing Commands 811
Interface Interface Mode Protocol State
--------- -------------- ----------------
vlan 10 Enable Non-Operational
vlan 20 Enable Non-Operational
show ipv6 pimdm interface
The show ipv6 pimdm interface command is used to display PIM-DM
Configuration information for all interfaces or for the specified interface. If
no interface is specified, Configuration of all interfaces is displayed.
Syntax
show ipv6 pimdm interface [ vlan vlan-id | all ]
• vlan vlan-id — A valid VLAN ID.
•
all — To show configuration information for all valid interfaces.
Default Configuration
There is no default configuration for this command.
Command Mode
Privileged EXEC mode
User Guidelines
There are no user guidelines for this command.
Example
console#show ipv6 pimdm interface vlan 10
Slot/Port...................................... vlan
10
IP Address.....................................
FE80::221:9BFF:FEC3:1216/128