RMON Commands 1183
rmon event
Use the rmon event command in Global Configuration mode to configure an
event. To remove an event, use the no form of this command. Also see the
show rmon events command.
Syntax
rmon event
index type
[community
text
]
[description
text
] [owner
name
]
no rmon event
index
•
index
— The event index. (Range: 1–65535)
•
type
— The type of notification that the device generates about this event.
Can have the following values:
none
,
log
,
trap
,
log-trap
. In the case of log,
an entry is made in the log table for each event. In the case of trap, an
SNMP trap is sent to one or more management stations.
•
community
text
— If an SNMP trap is to be sent, it is sent to the SNMP
community specified by this octet string. (Range: 0-127 characters)
•
description
text
— A comment describing this event. (Range 0-127
characters)
•
owner
name
— Enter a name that specifies who configured this event. If
unspecified, the name is an empty string.
Default Configuration
This command has no default configuration.
Command Mode
Global Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example configures an event with the trap index of 10.
console(config)#rmon event 10 log
To Next Page
Loading...
