Dell PowerConnect 6224 Command Line Interface Guide

396 Link Dependency Commands
link-dependency group
Use the link-dependency group command to enter the link-dependency
mode to configure a link-dependency group
Syntax
link-dependency group GroupId
• GroupId — Link dependency group identifier. (Range: 1–16)
Default Configuration
This command has no default configuration.
Command Mode
Global Configuration mode
User Guidelines
No specific guidelines
Example
console(config)#link-dependency group 1
console(config-linkDep-group-1)#
no link-dependency group
Use the no link-dependency group command to remove the configuration for
a link-dependency group.
Syntax
no link-dependency group GroupId
• GroupId — Link dependency group identifier. (Range: 1–16)
Default Configuration
This command has no default configuration.

Dell PowerConnect 6224 Specifications

General

Switching Capacity	128 Gbps
Forwarding Rate	95.2 Mpps
Power Supply	100-240 VAC, 50/60 Hz
RAM	128 MB
Flash Memory	32 MB
Layer Support	Layer 2/3
Stacking	Up to 12 units
Weight	12.1 lbs
MAC Address Table Size	16, 000
Jumbo Frame Support	Up to 9, 216 bytes
Operating Temperature	0°C to 45°C
Storage Temperature	-40°C to 70°C
Humidity	10% to 90% (non-condensing)
Ports	24 x 10/100/1000BASE-T
VLAN Support	Yes (802.1Q)
Dimensions	17.3 x 13.8 x 1.7 in (440 x 350 x 44 mm)