Dell PowerConnect 6224 - Password (User EXEC)

AAA Commands 199
Default Configuration
No password is specified.
Command Mode
Line Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example specifies a password "mcmxxyyy" on a line.
console(config-line)# password mcmxxyyy
password (User EXEC)
Use the password command in User EXEC mode to allow a user to change
the password for only that user. This command should be used after the
password has aged. The user is prompted to enter the old password and the
new password.
Syntax
password
Default Configuration
There is no default configuration for this command.
Command Mode
User EXEC mode
User Guidelines
This command has no user guidelines.
Example
The following example shows the prompt sequence for executing the
password command.