Dell PowerConnect 6224 - Snmp-Server Enable Traps Authentication

SNMP Commands 1249
Example
The following example displays the options for the snmp-server enable traps
command.
console(config)#snmp-server enable traps ?
<cr> Press enter to execute the command.
acl acl
all Enable/Disable all Traps.
authentication To enable the device to send SNMP
traps when
authentication fails.
dvmrp dvmrp
link Enable/Disable switch level Link
Up/Down trap flag.
multiple-users Enable/Disable sending traps when
multiple logins
active.
ospf Enable/Disable OSPF Traps.
ospfv3 Enable/Disable OSPF Traps.
pim pim
spanning-tree Enable/Disable sending Spanning
Tree traps.
snmp-server enable traps authentication
Use the snmp-server enable traps authentication command in Global
Configuration mode to enable the switch to send Simple Network
Management Protocol traps when authentication fails. To disable SNMP
failed authentication traps, use the no form of this command.
Syntax
snmp-server enable traps authentication
no snmp-server enable traps authentication