Dell PowerConnect 6224 - Switchport Forbidden Vlan

VLAN Commands 593
console(config-if-1/g8)#switchport access vlan 23
switchport forbidden vlan
Use the switchport forbidden vlan command in Interface Configuration
mode to forbid adding specific VLANs to a port. To revert to allowing the
addition of specific VLANs to the port, use the remove parameter of this
command.
Syntax
switchport forbidden vlan {add vlan-list |remove vlan-list }
• add vlan-list — List of valid VLAN IDs to add to the forbidden list.
Separate nonconsecutive VLAN IDs with a comma and no spaces. Use a
hyphen to designate a range of IDs.
•
remove vlan-list — List of valid VLAN IDs to remove from the forbidden
list. Separate nonconsecutive VLAN IDs with a comma and no spaces. Use
a hyphen to designate a range of IDs.
Default Configuration
All VLANs allowed.
Command Mode
Interface Configuration (Ethernet, port-channel) mode
User Guidelines
This command has no user guidelines.
Example
The following example forbids adding VLAN numbers 234 through 256 to
port 1/g8.
console(config)#interface ethernet 1/g8
console(config-if-1/g8)#switchport forbidden vlan add
234-256