Dell PowerConnect 6224 - Redirect

478 QoS Commands
The policy type dictates which of the individual policy attribute commands
are valid within the policy definition.
Example
The following example shows how to establish a new DiffServ policy named
"DELL."
console(config)#policy-map DELL
console(config-policy-classmap)#
redirect
Use the redirect command in Policy-Class-Map Configuration mode to
specify that all incoming packets for the associated traffic stream are
redirected to a specific egress interface (physical port or port-channel).
Syntax
redirect interface
• interface — Specifies any valid interface. Interface is Ethernet port or
port-channel (Range: lag1–lag18)
Default Configuration
This command has no default configuration.
Command Mode
Policy-Class-Map Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example shows how to redirect incoming packets to port 1/g1.
console(
config-policy-classmap)#redirect 1/g1