604 VLAN Commands
console(config-vlan)#
vlan makestatic
This command changes a dynamically created VLAN (one that is created by
GVRP registration) to a static VLAN (one that is permanently configured and
defined). The ID is a valid VLAN identification number. VLAN range is 2-
4093.
Syntax
vlan makestatic
vlan-id
•
vlan-id
— Valid vlan ID. Range is 2–4093.
Default Configuration
This command has no default configuration.
Command Mode
VLAN Database Mode
User Guidelines
The dynamic VLAN (created via GRVP) should exist prior to executing this
command. See the Type column in output from the show vlan command to
determine that the VLAN is dynamic.
Example
The following changes vlan 3 to a static VLAN.
console(config-vlan)#vlan makestatic 3
vlan protocol group
Use the vlan protocol group command in Global Configuration mode to add
protocol-based groups to the system. When a protocol group is created, it is
assigned a unique group ID number. The group ID is used to identify the
group in subsequent commands. Use the no form of the command to remove
the specified VLAN protocol group name from the system.
To Next Page
Loading...
