VLAN Commands 605
If multiple vlan protocol groups are created, deletes one of the groupd, and
then saves the configuration, the older implementation of this command
resulted incorrectly applying the groupids on reload. So, the existing
command vlan protocol group <groupname> is updated to vlan protocol
group <groupid> so that groupid is used for both configuration and script
generation.
NOTE:
If an attempt is made to migrate to the latest implementation with any of the
groupnames deleted prior to saving configuration on the pre 3.0.0.x code
(applicable only for platforms PC62xx, PCM622x, PCM8024), the problem on the
latest code will remain.
Syntax
vlan protocol group <
groupid
>
no vlan protocol group <
groupid
>
•
groupid
— The protocol-based VLAN group ID, to create a protocol-based
VLAN group. To see the created protocol groups, use the show port
protocol all command.
Default Configuration
This command has no default configuration.
Command Mode
Global Configuration mode
User Guidelines
This command has no user guidelines.
Example
console(config)# vlan protocol group 1
vlan protocol group add protocol
Use the vlan protocol group add protocol command in Global Configuration
mode to add a protocol to the protocol-based VLAN groups identified by
groupid
. A group may have more than one protocol associated with it. Each
interface and protocol combination can be associated with one group only. If
To Next Page
Loading...
