Dell PowerConnect 6224 - Clear Arp-Cache; Clear Arp-Cache Management; Ip Proxy-Arp; Show Arp

90 Command Groups
Layer 3 Commands
ARP (IPv4)
DHCP and BOOTP Relay (IPv4)
Command Description Mode*
arp Creates an Address Resolution Protocol (ARP)
entry.
GC
arp cachesize Configures the maximum number of entries in
the ARP cache.
GC
arp dynamicrenew Enables the ARP component to automatically
renew dynamic ARP entries when they age out.
GC
arp purge Causes the specified IP address to be removed
from the ARP cache.
PE
arp resptime
Configures the ARP request response timeout. GC
arp retries Configures the ARP count of maximum request
for retries.
GC
arp timeout Configures the ARP entry age-out time. GC
clear arp-cache Removes all ARP entries of type dynamic from
the ARP cache.
PE
clear arp-cache
management
Removes all entries from the ARP cache learned
from the management port.
PE
ip proxy-arp Enables proxy ARP on a router interface. IC
show arp Displays the Address Resolution Protocol (ARP)
cache.
PE
show arp brief Displays the brief Address Resolution Protocol
(ARP) table information.
PE
NOTE: *For the meaning of each Mode abbreviation, see "Mode Types" on page 60.
Command Description Mode*
bootpdhcprelay
cidridoptmode
Enables the circuit ID option and remote agent
ID mode for BootP/DHCP Relay on the system.
GC