Dell PowerConnect 6224 - Show Link-Dependency

402 Link Dependency Commands
Example
console(config-linkDep-group-1)# no depends-on port-
channel 6
show link-dependency
Use the show link-dependency command to show the link dependencies
configured for a particular group. If no group is specified, then all the
configured link-dependency groups are displayed.
Syntax
show link-dependency [group GroupId ]
• GroupId — Link dependency group identifier. (Range: Valid Group Id,
1–16)
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode
User Guidelines
No specific guidelines
Example
The following command shows link dependencies for all groups.
console#show link-dependency
GroupId Member Ports Ports Depended On
------- --------------------- ----------------------
------------
2 1/g1-1/g4 1/g8-1/g9
3 1/g5 ch2
5 1/g3-1/g4 1/g10