1102 Clock Commands
•
priority —
Priority assigned to the server. (Range: 1–8)
Default Configuration
No servers are defined.
Command Mode
Global Configuration mode
User Guidelines
Up to 8 SNTP servers can be defined.
Use the sntp client enable command in Global Configuration mode to
enable unicast clients globally.
Polling time is determined by the sntp client poll timer <64-1024> global
configuration command.
Example
The following example configures the device to accept Simple Network Time
Protocol (SNTP) traffic from the server at IP address 192.1.1.1.
console(config)# sntp server 192.1.1.1
sntp trusted-key
Use the sntp trusted-key command in Global Configuration mode to
authenticate the identity of a system to which Simple Network Time Protocol
(SNTP) will synchronize. To disable authentication of the identity of the
system, use the no form of this command.
Syntax
sntp trusted-key
key-number
no sntp trusted-key
key-number
•
key-number —
Key number of authentication key to be trusted. (Range:
1–4294967295)
To Next Page
Loading...
