640 802.1x Commands
Port Username
--------- ---------
1/g1 Bob
The following table describes the significant fields shown in the display:
802.1x Advanced Features
dot1x guest-vlan
Use the dot1x guest-vlan command in Interface Configuration mode to set
the guest VLAN on a port. The VLAN must already have been defined. The
no form of this command sets the guest VLAN id to zero, which disables the
guest VLAN on a port.
Syntax
dot1x guest-vlan
vlan-id
no dot1x guest-vlan
•
vlan-id
— The ID of a valid VLAN to use as the guest VLAN (Range: 0-
4093).
Default Configuration
The guest VLAN is disabled on the interface by default.
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
Configure the guest VLAN before using this command.
Field Description
Username The username representing the identity of the Supplicant.
Port The port that the user is using.
To Next Page
Loading...
