Dell PowerConnect 6224 - Show Bridge Multicast Address-Table Count; Show Ip Mcast; Show Ip Mcast Boundary; Show Ip Mcast Interface

102 Command Groups
OSPF
show bridge multicast
address-table count
Displays statistical information about the
entries in the multicast address table.
PE
show ip mcast Displays the system-wide multicast
information.
PE
show ip mcast boundary Displays the system-wide multicast
information.
PE
show ip mcast interface Displays the multicast information for the
specified interface.
PE
show ip mcast mroute Displays a summary or all the details of the
multicast table.
PE
show ip mcast mroute
group
Displays the multicast configuration settings of
entries in the multicast mroute table.
PE
show ip mcast mroute
source
Displays the multicast configuration settings of
entries in the multicast mroute table.
PE
show ip mcast mroute
static
Displays all the static routes configured in the
static mcast table.
PE
show ip pimsm bsr Displays the bootstrap router (BSR)
information.
PE
show ip pimsm interface Displays interface config parameters. If no
interface is specified, all interfaces are
displayed.
PE
show ip pimsm rp-hash Displays which rendezvous point (RP) is being
selected for a specified group.
PE
show ip pimsm rp mapping Displays all group-to-RP mappings of which the
router is aware (either configured or learned
from the bootstrap router).
PE
NOTE: *For the meaning of each Mode abbreviation, see "Mode Types" on page 60.
Command Description Mode*
area default-cost Configures the monetary default cost for the stub
area.
ROSPF
Command Description Mode*