Dell PowerConnect 6224 - Default-Metric

Routing Information Protocol Commands 1017
Command Mode
Router RIP Configuration mode.
User Guidelines
This command has no user guidelines.
Example
console(config-router)#default-information originate
default-metric
Use the default-metric command in Router RIP Configuration mode to set a
default for the metric of distributed routes. Use the no form of the command
to return the metric to the default value.
Syntax
default-metric integer
no default-metric
• integer — Metric for the distributed routes. (Range: 1-15)
Default Configuration
Default metric is not configured by default.
Command Mode
Router RIP Configuration mode.
User Guidelines
This command has no user guidelines.
Example
The following example sets a default of 12 for the metric of distributed
routes.
console(config-router)#default-metric 12