Dell PowerConnect 6224 - Configuration; Enable

Captive Portal Commands 1067
configuration
Use the configuration command to enter the captive portal instance mode.
The captive portal configuration identified by CP ID 1 is the default CP
configuration. The system supports a total of ten CP configurations. Use the
“no” form of this command to delete a configuration. The default
configuration cannot be deleted.
Syntax
configuration cp-id
no configuration cp-id
• cp-id —Captive Portal ID (Range: 1–10).
Default Configuration
There is no default configuration for this command.
Command Mode
Captive Portal Configuration mode.
User Guidelines
There are no user guidelines for this command.
Example
console(config-CP)#configuration 2
console(config-CP 2)#
enable
Use the enable command to enable a captive portal configuration. Use the
“no” form of this command to disable a configuration.
Syntax
enable
no enable