OSPFv3 Commands 965
User Guidelines
The grace period must be set long enough to allow the restarting router to
reestablish all of its adjacencies and complete a full database exchange with
each of those neighbors.
Example
–
passive-interface
Use the passive-interface command to set the interface or tunnel as passive.
It overrides the global passive mode that is currently effective on the interface
or tunnel. Use the “no” form of this command to set the interface or tunnel
as non-passive.
Syntax
passive-interface {vlan
vlan-id
| tunnel
tunnel-id
}
no passive-interface {vlan
vlan-id
| tunnel
tunnel-id
}
•
vlan-id
— The vlan number
•
tunnel-id
— Tunnel identifier. (Range: 0–7)
Default Configuration
Passive interface mode is disabled by default.
Command Mode
Router OSPFv3 Configuration mode.
User Guidelines
There are no user guidelines for this command.
Example
console(config-router)#passive-interface vlan 1
To Next Page
Loading...
