Dell PowerConnect 6224 - Show Ip Arp Inspection Vlan

282 Dynamic ARP Inspection Commands
VLAN DHCP ACL DHCP ACL Bad
Src Bad Dest Invalid
Drops Drops Permits Permits MAC
MAC IP
---- ---------- ---------- ---------- ---------- ----
------ ---------- ---------
10 11 1 65 25
1 1 0
20 1 0 8 2
0 1 1
show ip arp inspection vlan
Use the show ip arp inspection vlan command to display the Dynamic ARP
Inspection configuration on all the VLANs in the given VLAN range. It also
displays the global configuration values for source MAC validation,
destination MAC validation and invalid IP validation.
Syntax
show ip arp inspection vlan [ vlan-range ]
vlan-range — A valid VLAN range.
Default Configuration
There is no default configuration for this command.
Command Mode
Privileged EXEC mode
User Guidelines
The following global parameters are displayed:
Source Mac Validation If Source Mac validation of ARP frame is enabled.
Destination Mac
Validation
If Destination Mac validation of ARP Response frame is
enabled.