Dell PowerConnect 6224 - Show Copper-Ports Tdr

1164 PHY Diagnostics Commands
show copper-ports cable-length
Use the show copper-ports cable-length command in Privileged EXEC mode
to display the estimated copper cable length attached to a port.
Syntax
show copper-ports cable-length [ interface ]
• interface — A valid Ethernet port. The full syntax is unit / port.
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode
User Guidelines
The port must be active and working in a 100M or 1000M mode.
Example
The following example displays the estimated copper cable length attached to
all ports.
console#show copper-ports cable-length
Port Length [meters]
---- ---------------
1/g1 <50
1/g2 Copper not active
1/g3 110-140
1/g4 Fiber
show copper-ports tdr
Use the show copper-ports tdr command in Privileged EXEC mode to display
the last Time Domain Reflectometry (TDR) tests on specified ports.