1148 Line Commands
Telnet configuration:
Interactive timeout: 10 minutes 10 seconds
History: 10
SSH configuration:
Interactive timeout: 10 minutes 10 seconds
History: 10
speed
Use the speed command in Line Configuration mode to set the line baud
rate. Use the no form of the command to restore the default settings.
Syntax
speed {
bps
}
no speed
•
bps
— Baud rate in bits per second (bps). The options are 2400, 9600,
19200, 38400, 57600, and 115200.
Default Configuration
This default speed is 9600.
Command Mode
Line Interface (console) mode
User Guidelines
This configuration applies only to the current session.
Example
The following example configures the console baud rate to 9600.
console(config-line)#speed 9600
To Next Page
Loading...
