Dell PowerConnect 6224 - Show Port Protocol

VLAN Commands 587
Port 2/g19 is member in:
VLAN Name Egress rule Type
---- --------- ----------- -----
2921 Primary A untagged Static
2922 Community A1 untagged Static
Static configuration:
PVID: 2922
Ingress Filtering: Enabled
Acceptable Frame Type: Untagged
GVRP status: Disabled
Port 2/g19 is member in:
VLAN Name Egress rule Type
---- --------- ----------- -----
2921 Primary A untagged Static
2922 Community A1 untagged Static
show port protocol
Use the show port protocol command in Privileged EXEC mode to display
the Protocol-Based VLAN information for either the entire system or for the
indicated group.
Syntax
show port protocol { groupid | all}
• groupid — The protocol-based VLAN group ID, which is automatically
generated when you create a protocol-based VLAN group with the
vlan
protocol group
command.
•
all — Enter all to show all interfaces.