Dell PowerConnect 6224 - Ip Telnet Port

1348 Telnet Server Commands
ip telnet server disable
The ip telnet server disable command is used to enable/disable the Telnet
service on the switch.
Syntax
ip telnet server disable
no ip telnet server disable
Parameter Ranges
Not applicable
Command Mode
Global Configuration
Usage Guidelines
No specific guidelines.
Default Value
This feature is enabled by default.
Example
console#configure
console(config)#ip telnet server disable
console(config)# no ip telnet server disable
ip telnet port
The ip telnet port command is used to configure the Telnet service port
number on the switch.
Syntax
ip telnet port port number
• port number — Telnet service port number (Range: 1–65535)