Tunnel Interface Commands 1033
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode.
User Guidelines
This command has no user guidelines.
Examples
The following examples show the parameters related to an individual tunnel
and to all tunnel interfaces.
console#show interfaces tunnel 1
Interface Link Status.......................... down
MTU size....................................... 1480 bytes
console#show interfaces tunnel
TunnelId Interface TunnelMode SourceAddress Desti
nationAddress
-------- --------- ---------- ------------- ----
------------
1 tunnel
1 IPv6OVER4 10.254.25.14 10.254.25.10
2 tunnel
2 IPv6OVER4 10.254.20.10
tunnel destination
Use the tunnel destination command in Interface Configuration mode to
specify the destination transport address of the tunnel.
Syntax
tunnel destination
ipv4addr
no tunnel destination
To Next Page
Loading...
