898 OSPF Commands
Example
The following example configures OSPF protocol to allow redistribution of
routes from the specified source protocol/routers.
console(config-router)#redistribute rip metric 90
metric-type 1 tag 555 subnets
router-id
Use the router-id command in Router OSPF Configuration mode to set a 4-
digit dotted-decimal number uniquely identifying the router OSPF ID.
Syntax
router-id
ip-address
•
ip-address
— IP address that uniquely identifies the router OSPF ID.
Default Configuration
This command has no default configuration.
Command Mode
Router OSPF Configuration mode.
User Guidelines
This command has no user guidelines.
Example
The following example defines the router OSPF ID as 5.5.5.5.
console(config)#router ospf
console(config-router)#router-id 5.5.5.5
router ospf
Use the router ospf command in Global Configuration mode to enter Router
OSPF mode.
To Next Page
Loading...
