1302 System Management Commands
nsf
Use this command to enable non-stop forwarding. The “no” form of the
command will disable NSF.
Syntax
nsf
no nsf
Default Configuration
Non-stop forwarding is enabled by default.
Command Mode
Stack Global Configuration mode
User Guidelines
Nonstop forwarding allows the forwarding plane of stack units to continue to
forward packets while the control and management planes restart as a result
of a power failure, hardware failure, or software fault on the stack
management unit.
Example
console(config)#nsf
ping
Use the ping command in User EXEC mode to check the accessibility of the
desired node on the network.
Syntax
ping [ ip | ipv6 ]
ipaddress
|
hostname
[ repeat
count
] [ timeout
interval
] [
size
size
]
•
ipaddress
— IP address to ping (contact).
•
hostname
— Hostname to ping (contact) (Range: 1–158 characters).
•
count
— Number of packets to send (Range: 1–15 packets).
To Next Page
Loading...
