1124 Configuration and Image File Commands
interface ethernet 1/g2
ip address 176.243.100.100 255.255.255.0
duplex full
speed 1000
exit
show bootvar
Use the show bootvar command in User EXEC mode to display the active
system image file that the device loads at startup.
Syntax
show bootvar [
unit
]
•
unit
—Unit number.
Default Configuration
This command has no default configuration.
Command Mode
User EXEC mode
User Guidelines
This command has no user guidelines.
Example
The following example displays the active system image file that the device
loads at startup.
console>show bootvar
Image Descriptions
image1 : default image
image2 :
To Next Page
Loading...
