Dell PowerConnect 6224 - Show Ipv6 Mld Traffic

808 IPv6 Routing Commands
2 3 0 4 ----- -----
show ipv6 mld traffic
The show ipv6 mld traffic command is used to display MLD statistical
information for the router.
Syntax
show ipv6 mld traffic
Default Configuration
There is no default configuration for this command.
Command Mode
Privileged EXEC mode
User Guidelines
The following fields are displayed:
Valid MLD Packets
Received
The number of valid MLD packets received by the
router.
Valid MLD Packets Sent The number of valid MLD packets sent by the router.
Queries Received The number of valid MLD queries received by the
router.
Queries Sent The number of valid MLD queries sent by the router.
Reports Received The number of valid MLD reports received by the
router.
Reports Sent The number of valid MLD reports sent by the router.
Leaves Received The number of valid MLD leaves received by the router.
Leaves Sent The number of valid MLD leaves sent by the router.
Bad Checksum MLD
Packets
The number of bad checksum MLD packets received by
the router.
Malformed MLD Packets The number of malformed MLD packets received by the
router.