Dell PowerConnect 6224 - Vlan Routing

VLAN Commands 607
Syntax
vlan protocol group name < groupid > < groupName >
no vlan protocol group name <
groupid >
• groupid —The protocol-based VLAN group ID, which is automatically
generated when you create a protocol-based VLAN group with the
vlan
protocol group
command. To see the group ID associated with the name
of a protocol group, use the
show port protocol all command
•
groupName —The group name you want to add. The group name can be
up to 16 characters length. It can be any valid alpha numeric characters.
Default Configuration
This command has no default configuration.
Command Mode
Global Configuration mode
User Guidelines
This command has no user guidelines.
Example
console(config)# vlan protocol group name 1 usergroup
vlan protocol group remove
Use the vlan protocol group remove command in Global Configuration
mode to remove the protocol-based VLAN group identified by
groupid .
Syntax
vlan protocol group remove groupid
vlan routing
Use the vlan routing command to enable routing on a VLAN. Use the “no”
form of this command to disable routing on a VLAN.