Dell PowerConnect 6224 - Show Interfaces Detail

300 Ethernet Configuration Commands
---- ------------------------------------------------
-----------
1/g1 Port that should be used for management only
2/g1
2/g2
Ch Description
---- -----------
1 Output
show interfaces detail
Add support for a single command that shows VLAN info, STP info, Port
status info, Port configuration info. Add a command which wraps all the port
commands into a single command.
Syntax
show interfaces detail [ethernet interface | port-channel port-channel port-
channel-number
]
• interface — A valid Ethernet port.
•
port-channel-number — A valid port-channel trunkindex.
Default Configuration
There is no default configuration for this command.
Command Mode
User EXEC mode
User Guidelines
The command will be show interfaces detail {ethernet interface | port-
channel port-channel-number} where
• interface—A valid Ethernet port.