SNMP Commands 1253
snmp-server group
Use the snmp-server group command in Global Configuration mode to
configure a new Simple Management Protocol (SNMP) group or a table that
maps SNMP users to SNMP views. To remove a specified SNMP group, use
the no form of this command.
Syntax
snmp-server group
groupname
{ v1 | v2 | v3 { noauth | auth | priv } [
notify
notifyview
] } [ context
contextname
] [ read
readview
] [ write
writeview
]
no snmp-server group
groupname
{ v1 | v2 | v3 { noauth | auth | priv } } [
context
contextname
]
•
groupname
— Specifies the name of the group. (Range: 1-30 characters.)
•
v1
— Indicates the SNMP Version 1 security model.
•
v2
— Indicates the SNMP Version 2 security model.
•
v3
— Indicates the SNMP Version 3 security model.
•
noauth
— Indicates no authentication of a packet. Applicable only to the
SNMP Version 3 security model.
•
auth
— Indicates authentication of a packet without encrypting it.
Applicable only to the SNMP Version 3 security model.
•
priv
— Indicates authentication of a packet with encryption. Applicable
only to the SNMP Version 3 security model.
•
contextname
— Provides different views of the system and provides the
user a way of specifying that context.
•
notifyview
— Defines a string that is the name of the view that enables
specifying an inform or a trap. If unspecified, nothing is defined for the
notify view. (Range: 1-30 characters.)
•
readview
— A string that is the name of the view that enables the you to
view only the contents of the agent. If unspecified, all the objects except
for the community-table and SNMPv3 user and access tables are available.
(Range: 1-30 characters.)
To Next Page
Loading...
