444 Port Monitor Commands
monitor session
Use the monitor session command in Global Configuration mode to
configure a probe port and a monitored port for monitor session (port
monitoring). Use the src-interface parameter to specify the interface to
monitor. Use rx to monitor only ingress packets, or use tx to monitor only
egress packets. If you do not specify an {rx | tx} option, the destination port
monitors both ingress and egress packets. Use the destination interface to
specify the interface to receive the monitored traffic. Use the mode parameter
to enabled the administrative mode of the session. If enabled, the probe port
monitors all the traffic received and transmitted on the physical monitored
port.
Syntax
monitor session
session-id
{source interface
src-interface
[rx | tx] |
destination interface
dst-interface
| mode}
no monitor session
•
session id
— Session identification number.
•
src-interface
— Ethernet interface (Range: Any valid Ethernet Port)
•
rx
— Monitors received packets only. If no option specified, monitors both
rx and tx
•
tx
— Monitors transmitted packets only. If no option is specified, monitors
both rx and tx.
•
dst-interface
— Ethernet interface (Range: Any valid Ethernet Port)
Default Configuration
This command has no default configuration.
Command Mode
Global Configuration mode
User Guidelines
This command has no user guidelines.
To Next Page
Loading...
