Dell PowerConnect 6224 - Show Interfaces Loopback

824 Loopback Interface Commands
interface loopback
Use the interface loopback command in Global Configuration mode to enter
the Interface Loopback configuration mode.
Syntax
interface loopback loopback-id
no interface loopback loopback-id
• loopback-id — Loopback identifier. (Range: 0-7)
Default Configuration
This command has no default configuration.
Command Mode
Global Configuration mode.
User Guidelines
This command has no user guidelines.
Example
The following example enters the Interface Loopback 1 configuration mode.
console(config)# interface loopback 1
console(config-if-loopback1)#
show interfaces loopback
Use the show interfaces loopback command in Privileged EXEC mode to
display information about one or all configured loopback interfaces.
Syntax
show interfaces loopback [ loopback-id ]
• loopback-id — Loopback identifier. (Range: 0-7)