SNMP Commands 1247
snmp-server contact
Use the snmp-server contact command in Global Configuration mode to set
up a system contact (sysContact) string. To remove the system contact
information, use the no form of the command.
Syntax
snmp-server contact
text
no snmp-server contact
•
text
— Character string, 0 to 160 characters, describing the system contact
information.
Default Configuration
This command has no default configuration.
Command Mode
Global Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example displays setting up the system contact point as
"Dell_Technical_Support".
console(config)# snmp-server contact
Dell_Technical_Support
snmp-server enable traps
Use the snmp-server enable traps command to enable SNMP traps globally or
to enable specific SNMP traps. Use the “no” form of this command to disable
SNMP traps. See Granular OSPF v2/v3 Traps for more detail about the OSPF
trap types.
To Next Page
Loading...
